Beckett GeniSys Contractor Tool Instrukcja Użytkownika

Description / ApplicationsThe Beckett GeniSysTM Display is an optional attachment for the GeniSys Primary Control that allows a technician to monitor

Page 10Screen Message Sensor/Monitor/MessageNotes/Checks### ohms avg Cad Cell Historical cycle data located in Control. Average Cad Cell resis-tance

Page 11

Form No. 61687 R04, Printed in USA 06/09CORPORATIONUSA: P.O. Box 1289 ● Elyria, OH 44036 ● Phone: 800-OIL-BURN (800-645-2876)Canada: R.W. Beckett

Page 2InstallationWith a slotted screwdriver, carefully remove the COM2 port cover on the right side of the GeniSys control. When installing the displ

Page 3The display was designed to function as both a monitor and a programmer. The display consists of two rows of 16 alphanumeric characters. Below

Page 4Standby - During this time, the burner is idle and waiting for a signal to turn on.Pre-time - The Pre-time screen will display the number of sec

Page 5Pressing the BACK (NO) key at this stage will return the display to the VIEW HISTORY screen. Pressing the PREV key will display the hours since

Page 6►NEXTCycle End Reason* * The possible cycle end reasons are as follows, Recycled - The burner was shut down bec

Page 7To return to the CYCLE HISTORY screen, press BACK (NO) once. To return to the BURNER HISTORY screen, press BACK (NO) a second time. C. Pre-time

Page 8D. Post-time Set ProgramFrom the PRE-TIME, SELECT TO CHANGE screen, press the NEXT key to access the POST-TIME (motor off delay), SELECT TO CHAN

Page 9E. Service Message ProgramFrom the POST-TIME CHANGE screen, pressing the NEXT key will display the SERVICE MESSAGE, SELECT TO CHANGE programmin